new

TSZ-UNI-ET Concrete Step Handles

Send request

Suitable for picking and moving steps, kerbstones, block steps and edge angles with a wheel loader or forklift truck.

Further information

Easily adjustable opening width by means of a spring-loaded bolt.
Considerable inside height. Conical kerb stones are also gripped securely, as the gripper has an inside height of 185 mm (7¼ inch) thus being able to grip underneath the conical form.
Fork sleeve with lifting eye and manual turning device, engaging every 90°. Thus the TSZ-UNI can be picked-up with the fork lift truck tines.
Automatic release for fully automatic switch-over from “full” to “empty”.
Exchangeable profiled rubber seals.
Can also be used for crane hooks, for example.
Galvanised finish.

Technical details

TSZ-UNI-ET:

TSZ-UNI step positioning pliers with integrated insertion pocket and suspension eye. Manual turning device engages after 90°. This allows the TSZ-UNI-ET to be picked up with the forks of a wheel loader or forklift truck.
Advantage: Insertion pocket is vertical, forklift truck can enter directly.

Type	Order no.	Gripping Range	Inside Height	Working Load Limit/WLL	Length of Gripper
TSZ-UNI-ET	53100443	1,97-23,62 in	7,28 in	1323 lbs	13,78 in

Accessories

HVA-FTZ/TSZ (grey):

for all versions of FTZ-UNI/MAXI/MULTI and TSZ-UNI. Grey rubber. Adjustable range TSZ-UNI/MAXI approx. 55 – 140 mm.
Adjustable range FTZ-UNI/MAXI-25 and FTZ-UNI/MULTI-15 approx. 120 – 255 mm.
FTZ-UNI-50 approx. 55 – 155 mm. FTZ-MAXI-50 approx. 55 – 195 mm.

TSZ-UNI-WB-SQ:

Special steelfinger grippers allow for safe installation of roughly-cut ashlar rocks. The steel-finger grippers can be screwed on the clamp in just a few simple steps for (all TSZ-UNI built in or after 2009, order number 53100338).